Build a Disc Mount

We show you how to build your own disc mount in less than 10 seconds to store and display your favorite CD's and DVD's.

The Disc Mount is quick and easy to build. No tools are needed, except clean fingers.

Assembled and ready to use.


Disc Mounts
Assembled and ready to use.
Only $7.95 for 12.

Build Steps

Be aware that safety is your responsibility. Please read our Safety Warning and Disclaimer before you start.

Step 1: Get Parts

To build a disc mount you will need the following:

  • 1, foam cd hub (0.52 in. diameter x 0.375 in. thick)
  • 1, nylon washer (0.85 in. diameter x 0.395 in. diameter hole x 0.062 in. thick)
  • 1, neodymium magnet (Ni-Cu-Ni plated, 0.375 in. diameter x 0.062 in. thick)
  • 1, white vinyl sticker (0.75 in. diameter)

Clockwise, left to right: white vinyl sticker, neodymium magnet, foam cd hub, nylon washer.

Step 2: Stick Foam Hub to Washer

Foam CD hubs come with one side that is sticky. Place the sticky side of the foam hub onto the center of the washer. It doesn't have to be perfectly in the center, just close. To make sure the adhesive sticks, apply firm pressure between the foam hub and washer for 2 seconds. Do not flatten/crush the foam hub.

PIC 2-1
PIC 2-2
PIC 2-3

Step 3: Place Magnet into Washer

Flip over the hub-washer assembly. Place the magnet into the hole in the back of washer-hub assembly. To make sure the adhesive sticks, apply firm pressure between the magnet and foam hub for 2 seconds. Do not flatten/crush the foam.

PIC 3-1
PIC 3-2
PIC 3-3

Step 4: Cover Magnet with Sticker

Place the sticky side of the vinyl sticker in the center of the washer to cover the magnet. This doesn't have to be perfectly in the center, just close. To make sure the adhesive sticks to the washer, apply firm pressure to the vinyl sticker in a circular patten.

Congratulations! In less than 10 seconds you have built a disc mount. Check out our using guide to learn how to use and display your disc mount.

PIC 4-1
PIC 4-2
PIC 4-3

More Goodies...

Back to top